![]() ![]() The only thing I did with that drive was to install Windows 10. ![]() I never set a password for the Crucial MX300 M.2 drive installed in my NUC, and the drive was not installed in another PC before. ![]() To understand better, is this a hard disk that it was encrypted and installed in another PC and you install it in the NUC or you encrypted this disk using the NUC? However, although the drive may be encrypted, there is no password prompt on start-up, and I have no idea how to enable such a password prompt.ĪFAIK, Windows BitLocker supports OPAL, but I am running Windows 10 Home edition, so BitLocker is not an option.Īny comments would be greatly appreciated. It seems reasonable that the NUC6I3SYK BIOS does not offer to set a Hard Disk Drive Password for a drive that is already encrypted. One of its reports states:Īccording to User Guide of that software: "TCG is automatically enabled on drives that are initialized in systems running Windows 8 or later, or it can be enabled with third-party software utilities. I have installed the Crucial Storage Executive software to inspect the properties of that drive. I now believe that the installation of Windows 10 activated some sort of encryption on the Crucial MX300 275GB M.2 drive. Unfortunately, this did not bring the button back. When I realized that the SATA password button had disappeared, I updated the BIOS from 0051 to 0054. I am not referring to the BIOS User Password or the BIOS Supervisor Password, but the User hard disk drive password, as described in section 3.8 of the Technical Product Specification.I have never set any passwords, so there are no passwords that need be cleared. Sorry, but I don't think that your instructions apply to my problem: Place the configuration jumper back to its original position.Īlso, make sure you have the latest BIOS versions, if you don't have the latest BIOS you can download and follow the BIOS Update Instructions for Intel® NUC.Power off the computer and disconnect it from the power source.Select Clear BIOS User and Supervisor Passwords.Plug in the computer to the power source and power on the computer.Find and remove onboard configuration jumper.Disconnect the computer from the power source.Make sure the computer and any attached devices are powered off.Please remove the jumper that is located inside of the NUC, follow these steps: Please try the following to clear your password and then you can set it up again. Thank you for joining the Intel community. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |